10 kN | |
1500 rpm | |
3000 rpm | |
25x5 | |
13.7 | |
21.5 | |
0.06 | |
Aluminium, corrosion-resistant | |
Steel, case-hardened, ground | |
28 kg | |
20 kg | |
Synthetic fluid grease | |
Grease lubrication | |
max. 60°, higher on request | |
N: 0.478 kg cm² / L: 0.233 kg cm² | |
max. 13.5 Nm (N) / max. 7.5 Nm (L) | |
max. 57 Nm | |
Translating (S) |
R-Screw | rotating
The spindle is fixed to the worm wheel and rotates with it. The nut therefore moves up and down.
S-Screw | translating
The worm wheel has an internal thread and transforms rotary motion into linear movements as long as the spindle is prevented from rotating.
Pivot bushes are incorporated in the gearbox housing for screw jack series ZE, ZE-H and Z. Swivel bushes can be subjected to the full nominal load with either compression or tension.
Placement
5kN – 25kN | Front and rear side
35kN – 1000kN | Lateral
Lubricate the ball screw KGT every 300 hours of effective operation. For heavy-duty systems every 100 hours. | |
Inspect the trapezoidal screw regularly and regrease it depending on the operating cycle. |
Depending on areas of use, through holes or blind tapped holes are advantageous.